Anycubic Photon Printer Owners 造訪社團 » 用戶發文

This print was going so well until the supports failed. Can someone help me realize what I did wrong?

Resin is Elegoo grey

翻譯年糕

How often do you hear the "suction" sound of the model coming off the FEP and is it a good indicator of continued success when the plate is so low you can't tell if it's failed or succeeded?

翻譯年糕

I've been trying to print a Vampire Killer for the better part of a week now and I think I've finally got it.

Question: If the base layer of the supports aren't 100% within the vat does that matter terribly? The only parts out of the print area are the edges of my supports.

Angled this way the width of this handle should be about 7 inches.

Anything I should look out for?

This is the largest print I've ever attempted. There are drain holes in the bottom where the handle will eventually slide in btw.

翻譯年糕

Whats the largest model you'd print?

I'm trying to print Richter/Simon Belmont's Vampire Killer with this design

https://www.thingiverse.com/thing:3271813

I scaled it up to 2500% as instructed but it doesnt fit on the build plate.

I split the handle between two models and hollowed it out with 6mm thickness but I'm worried that no matter how many supports I use it's going to be too heavy.
Thoughts? 翻譯年糕