Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Well, I don't remember the fan in the printer almost stops spinning when uv lamp and screen turn on to cure a layer when the printer was new... Something about to go wrong with the printer or do I remember wrong? ?

翻譯年糕

Ok, so I think we can rule out that it is a support issue. What's the issue? More than z wobble? (The problem is the lines that are visible from the middle of the part to the top.)

翻譯年糕

Hello there. I printed this last night and got severe horizontal lines beginning from the middle and to the top of the part. As you can see by the measurements, the only way to fit it on the buildplate is to place it vertically. Can the horizontal lines be countered with som supports on the flat sides of the part to stabilize it? I did not add such supports on my try last night, only "below" overhangs. Also, this is my first tall part, so maybe my photon suffers from insane z wobble too... ?

翻譯年糕

Hello there! Siraya tech blu (clear) question: Is it possible to use light support with this resin? Because my first attempt with it failed hard. Has worked fine with anycubic resin and primacreator resin in the same printer.

翻譯年糕

Hello there! Does anyone know any seller, who ships to Sweden, where I can buy Siraya tech blu or any similar resin?

翻譯年糕