Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Travis Tuttle
2019-11-10 09:55:30

Ok so I searched through this page for a little while to see if there was already an answer to my problem, but couldn’t find it so here we go. My last few prints, the bottoms of them are a bit warped, but the rest of the print comes out great. Regardless of the angle, the closest to the raft gets warped. I’ve adjusted my settings a bit, had a failed print due to not enough bottom exposure time, went from 50 to 40. Changed it to 45 bottom exposure time and it can out a lot better, but still slightly warped. I’m using anycubic clear, currently at 8 bottom layer count, 8 exposure time, 45 bottom exposure time. (Previously at 10, 10, 50) Also while I’m here, how much does the bottom layer count matter?

翻譯年糕

Fábio Nogueira
2019-11-10 10:19:38

Travis Tuttle
2019-11-10 10:25:28

Travis Tuttle
2019-11-10 10:26:31

Fábio Nogueira
2019-11-10 10:26:36

Travis Tuttle
2019-11-10 10:26:58

Fábio Nogueira
2019-11-10 10:28:04

Travis Tuttle
2019-11-10 10:30:22

Fred Bey
2019-11-10 11:43:14

Travis Tuttle
2019-11-10 11:44:42

Fred Bey
2019-11-10 11:49:08

Travis Tuttle
2019-11-10 11:52:48

Fred Bey
2019-11-10 11:53:52

原文網址 Travis Tuttle
2019-11-08 10:07:22

What’s the volume of the vat? I’m about to start a fairly large print, and don’t want to run out of resin halfway thru the night. Chitubox says it’ll take about 37 ml.

翻譯年糕

Nathaniel Red Weidner
2019-11-08 10:08:28

Travis Tuttle
2019-11-08 10:09:05

Dustin Oliverius
2019-11-08 10:43:02

Richard Shapiro
2019-11-08 10:45:37

Clint B. Kauffman
2019-11-08 11:19:43

原文網址 Travis Tuttle
2019-11-06 21:37:26

So I was using the anycubic clear resin, and my prints were coming out just fine. I got anycubic grey resin and tried that, and either it will print the raft and start to print supports, or not stick to the build plate at all. 3 prints failed, but checked level and adjusted settings but they all failed.

翻譯年糕

Patrick Haeflinger
2019-11-06 21:39:35