Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Trying to use the resin test strip with Elegoo ABS-like Translucent resin. I tested at .050 and came up with 16 seconds. I successfully printed at that setting. When curing it, I did notice that my UVA lamp doesn’t seem to do anything to it, unlike my Anycubic resin which does cure under it.

In any case, I tried the test strip today at .020 and came up with 16 seconds as well. Is this normal? I’m still new to all this, but I would have expected the smaller layer height to need less time.

翻譯年糕

Build date on the ticket inside was August 24. Haven’t opened the bottom yet, but based on the firmware, is this a Fauxton or Photon?

翻譯年糕