Could someone help me out with a sort of Failed print?
I've made some Lifepoint counters (picture below)
I printed Straight to the Bed to make sure the lettering wasn't angled but the Print came out perfect but no lettering (i guess due to Resin Filling and curing because the gap is too small), it is Deep enough being about 3.75 of the 7.25mm thickness of the token.
I'm trying an angled print right now at the usual 45ish with support but I would really like to print these without supports.
Any ideas about how to improve the print end of things?, the Digital sculpt is fully meshed & solid no faults.
翻譯年糕
Richard Flanagan
2019-08-22 22:19:54
Andre Dukes
2019-08-22 22:22:03
Richard Flanagan
2019-08-22 22:23:21
Jarrod Smith
2019-08-22 22:39:52
Andre Dukes
2019-08-22 22:42:46
Andre Dukes
2019-08-23 07:08:51
Andre Dukes
2019-08-23 07:08:59
Andre Dukes
2019-08-23 07:09:11
Andre Dukes
2019-08-23 07:09:25
Andre Dukes
2019-08-23 07:09:39
