Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi all, I have a quick question about room temperature. I keep my photon in garage. So far had no issues with prints, but the temperature outside was not really bad. But i suspect eventually will get bit colder outside so it will get colder in my garage. Last night was around minus 3 Celsius outside and +13 in garage. I guess this is still ok. But what is in your experience the room temperature that I should not print at any more or move the printer to a warmer place?

翻譯年糕

Hi All, I'm new to the group so first of all hello :) I got a photon last week and been printing every day now. I did around 10 prints so far all came out very nice but had 2 issues. On my 2nd to last print one of the elements did stick to the film and did not print. After removing it from the print there is a small cavity to the film in that place. Is it still ok to use that film? or should I replace. Then on my last print the model came out no problem but on the support base there was an extra resin attached to it. Was like a 3x3 cm flap and 1-2 layers thick. I did run an LCD test just in case but the screen is fine all pixels are glowing correctly. Any idea what could cause it?

翻譯年糕