Hey everyone, I am having a sudden issue. So, I have been printing for a couple months now, with no real issues (outside of not enough supports and stuff on user error). Now, I'm trying to print a simple box. Each side is separate so i stacked them side by side, tilted them so i could put some supports to prop it up and help ensure that its a good print. However, its been 5 tires and they all fail. It prints the base of the supports, then starts to print the lower supports, and fails after a few layers into the actual print. I'm at a loss. I tried tilting, adding/sub supports, printing each side by itself, changed the resin, tested the UV light, re-leveled a few times and more. Its a little cold in the room, but still within range of the bottle recommendations. Any ideas?
翻譯年糕
Alwin Chan
2020-02-11 07:47:28
David Altman
2020-02-11 07:49:17
Alwin Chan
2020-02-11 07:50:44
David Altman
2020-02-11 08:01:39
Dan Elent
2020-02-11 08:11:48
Dan Elent
2020-02-11 08:12:42
David Altman
2020-02-11 08:18:28
David Altman
2020-02-13 03:42:45
Alwin Chan
2020-02-13 07:31:29
David Altman
2020-02-13 07:36:23
David Altman
2020-02-13 07:37:29
Alwin Chan
2020-02-13 08:07:28
David Altman
2020-02-13 08:22:59
