Hi all,
I was having some kind of issues with two of my latest printers. They are Anycubic Photon, not S.
Their LCD screen are making strange bands between layers.
Not always but in the most of the steps between one layer and other, it makes a band along all the print surface.
I send pictures from two prints I made with this problem.
When it happen to pieces like this, there is no problem, I can sand the part affected. It is a waste of resin but ok, I can "survive" that temporarily.
But when it happen to a miniature or a high detailed piece, it basicly brokes the piece or make it weaker and uglier.
What can be the cause of this problem?
I want to think that could be a software problem because the LCD is opening and closing well without problems appart than this strange layer of bands.
If any of you can help me I will thank you a lot.
翻譯年糕
Deodatta Daulat Gosavi
2020-03-16 18:27:39
Carlo Mariani
2020-03-16 18:33:49
Tried with Photon slicer and chitubox. I have other 4 photons and with the same files they print all well.
Carlo Mariani
2020-03-16 18:35:16
Deodatta Daulat Gosavi
2020-03-16 18:41:15
oh ... seems like weaken LCD then
Carlo Mariani
2020-03-16 18:48:18
It happen in two printers at the same time. I bought this both in the same order. Could be a firmware problem or I must replace the LCD sure?
I have LCD but, It's cheaper the other solution hehehe
Deodatta Daulat Gosavi
2020-03-16 18:49:24
Mail to Anycubic they will help you with latst firmware and debug the current one ...if not solved ... then only take step to replace LCD
Carlo Mariani
2020-03-16 18:50:19
Simon Leclerc
2020-03-16 19:14:50
what is your firmware version?
Carlo Mariani
2020-03-16 19:58:01
the latest -1, I mean, I usually update all with the previous version than the current one
Simon Leclerc
2020-03-17 00:13:54
Carlo Mariani
2020-03-17 01:52:40
Simon Leclerc
as I remember the version I discard it is .19 so it might be .18
Simon Leclerc
2020-03-17 06:20:58
