I recently moved to the Siraya Tech
Fast (1kg) ABS-Like Fast Curing Non-Brittle 3D Printing
Resin
(Grey)
. They had their own google doc so I tried to go by that and used these settings in the picture attached.
The overall print quality is .. fine. The support disconnects are fine, but there's a lot of stuck residue on the vat FEP film after every print. Any suggestions for changes to setting to help correct this?
翻譯年糕
Tim Borschel
2020-03-24 03:03:46
I run my saraiya tech fast grey at 7 bottom layers atb70 seconds and 9second exposure on my photon, I dont get the resin slime very often. Make sure you're in the 4.2.18 firmware if you have an og photon
Ray Powers
2020-03-24 03:09:18
I'll give those a shot next print and see if it solves my problem, thanks!
Fred Bey
2020-03-24 06:43:24
Be careful, the ABS like needs higher exposure than the regular fast resin. When I was running ABS like gray on my og photon, it was more like 13-14 seconds at .050
Ray Powers
2020-03-24 06:47:38
Fred Bey
If Tm's version does not work Ill try that next
Tim Borschel
2020-03-24 08:57:40
Fred Bey
I started with it at 11 seconds, but my prints were over exposed and the details were soft, 9 works for me
Scott Pavlich
2020-03-24 10:28:32
How old is your lcd? Something like that isn’t generally an exposure problem...though you are about 2 sec higher than I run for that layer
Ray Powers
2020-03-24 21:05:23
Ray Powers
2020-03-24 21:33:20
Tim's numbers seemed to work well. A little spotting on the bottom but nothing strange like the first couple of times.
