Hello everybody, first post here. Love this group. Noob in 3d printing.
So, i tried to sculpt hulk in blender and gave it a try with my anycubic photon. I have some questions about the post processing after the print ends.
What is the workflow you follow for removing supports? I washed this one first with IPA and then i removed supports, and then i washed it again, but the scale is so small that i couldn't use some sandpaper and totaly remove the parts of the supports.
I uploaded some photos of sculpt in blender,the finished print (that i have painted with some primer), my support settings and my printing settings.
Anything you can help me with is really appreciated. Its really bad to have a successful print and then getting destroyed cause of the supports.
Thank you very much, keep up the great job everyone.
PS: Sorry for bad resolution in photos...little lighter for scale.
翻譯年糕
Danny Gonzalez
2020-02-01 22:10:46
Mark Reynolds
2020-02-01 22:13:33
Leon Bukan
2020-02-01 22:17:04
