I’m sorry that this is my 1st post and it’s seeking help. I have a new Photon S, just unboxed earlier today. Went through the setup, installed the jump drive, went to the print menu, and there are no files to select. Took the jump drive to the laptop, there were no files on the stick. Went to the Anycubic website, downloaded both the test print as well as the slicing software. The test print file comes sliced, loaded it onto the jump drive, still nothing on the print menu. Is there some special step that’s needed to get the test print active so it’s available to print?
Thank you in advance for any and all help.
翻譯年糕
Mike Van Iperen
2020-01-29 13:43:13
Marc Richards
2020-01-29 13:43:58
Dave Fletcher
2020-01-29 13:49:18
Guy Hartmann
2020-01-29 13:51:27
Edward Hill
2020-01-29 14:05:11
Dave Fletcher
2020-01-29 14:07:42
Penn Davies
2020-01-29 14:08:31
Dave Fletcher
2020-01-29 14:10:09
Dave Fletcher
2020-01-29 14:10:25
Jonathan Dunbar
2020-01-29 14:16:45
JP Legris
2020-01-29 14:49:35
Philip Coulson
2020-01-29 15:35:04
Pierre Dahlgren
2020-01-29 15:36:19
Edward Hill
2020-01-29 21:14:27
Penn Davies
2020-01-30 01:01:43
