Anycubic Photon Printer Owners 造訪社團 » 用戶發文

M'kay. I have done a lot of searching, and a lot of reading, and I just wanted solid confirmation before I go upgrading things.

I have the "Photon Upgraded" (per Anycubic's page). I haven't upgraded any firmware yet, as I was reading conflicting information on it. Is it okay to go ahead and upgrade that? All that I can get to print are the .pws files from the old Photon Workshop - it doesn't read .photon files, or any of the .pws files from the new Photon Workshop.

Thanks in advance - I'm only a couple of weeks into using and learning this, and I'm still about 50% perfect prints, 50% failed prints - most of my failed prints are support fails, and I really liked what I've seen with the new Photon Workshop.

翻譯年糕

I'm very new to this, so please forgive me if these are silly questions. I bought the Photon S. I've done all of my research on leveling, cleaning, etc. I've managed 3 successful prints out of....10 or so? My issue is my pieces are not sticking to the build plate. I am using the Anycubic Eco resin in Macaroon Yellow (it's what came with it), and I've attached a photo of my slicer settings - I'm not certain of the settings, since that color doesn't appear to be on the chart, and I haven't been able to track down what anyone uses for that color. My FEP film is new and clear, the exposure test was fine, and my plate is level. Do I need to adjust my slicer settings? Should I just chuck the resin and try something else? Any help is appreciated. <3

翻譯年糕