So for some reason, I can only get adhesion on half of my plate, the other half always fails. Any idea why this might be happening?
所以出於某種原因, 我只能在我的一半盤子上粘合, 另一半總是失敗. 知道為甚麼會發生這種事嗎?
·
查看原文
·
為此翻譯評分
Paul Dodd
2020-03-18 03:27:17
Levelling, ensure the plates cleaned with IPA and dry
Wes Mischke
2020-03-18 04:07:45
Check you build plate is truly flat. Don’t sand it if it isn’t contact support. Just make sure it’s flat. If it is, leveling. Assuming lcd test is all good.
Simon Wilson
2020-03-18 04:15:14
Add a few seconds to base exposure time if your bed level attempts don't improve it. Last resort change base type from "skate" to "cylinder" in support settings, helped me and a few others
