Been printing fairly successfully! But noticing now and again getting little flappers like this at the edge of prints, no failure though. Any known cause? My last print also came off with a strange chip in an edge that should have been smooth. Minor issues but wondered how to avoid in future?
翻譯年糕
Vinny Bryant
2020-02-20 21:10:10
Peter Bucholc
2020-02-20 21:11:48
Shaun Spalding
2020-02-20 22:40:21
Stephen Hill
2020-02-20 23:47:53
Shaun Spalding
2020-02-20 23:50:32
Stephen Hill
2020-02-20 23:56:32
Peter Bucholc
2020-02-21 00:06:53
Serkan Budur
2020-02-21 04:34:05
Serkan Budur
2020-02-21 04:34:50
