I've had this start to happen lately, this one wasn't to bad, but some prints have been half hanging off, some models where affected, some just don't stick to the plate at all,
I have a fair few scratches and notches on my build plate , and a few dings and scratches on the FEp, assuming this is the problem
Curious if anyone else has seen this, it usually happens mid to late print, sometimes the model does this while over pieces are still printing on the same plate ?
翻譯年糕
Ray Sears
2020-03-20 16:11:06
Fred Steinmann
2020-03-20 16:17:12
Fred Bey
2020-03-20 17:00:21
Nicklas Rohde
2020-03-20 18:08:35
Viet Nguyen
2020-03-20 18:19:28
Dan Andersson
2020-03-20 19:29:34
Chad Elstad
2020-03-21 00:32:46
Mark Wardle
2020-03-21 00:53:56
