Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi everyone,

I'm wondering if there are dentists in this group that uses the Photon S for printing models, guides, splints...etc.

1. Which resin do you use?
2. What setting do you use to print the appliances to get the accuracy?
3. Which software do you use to modify the STL? Is meshmixer and Anycubic Workshop sufficient?

Thank you so kindly for sharing your experience.

翻譯年糕

Hi everyone, I'm completely new to 3D printing. Recently got the Photon S. Still learning about the software and the technical things.

I have just done my first print and I have a few questions and hope you guys can help me.

1. I'm using the printer to print dental models. I'm wondering what sort of setting I should have for the details I require? Where do I change the setting? Is it in the Anycubic Workshop?

2. After I print the models. I clean the model with 70% isopropyl. And I leave the model in a ultrasonic bath of the same solution for 5 min. I still get some white residual on the model.
Is this due to the uncured resin?
Is the concentration of 70% adequate? Or do I need a higher concentration?
What is your protocol on post printing products?

Your kind assistance is greatly appreciated ?

翻譯年糕