Anycubic Photon Printer Owners 造訪社團 » 用戶發文

First use a new USB stick if you're using the one that came with the printer. Second make sure if you're plugged into a surge protector, 1. It's new 2. It's not overworked

the USB isn't new but is a sandisk one. and currently plugged straight into the mains in the garage. only had the light and printer running today compared to last night with the heater and laptop as well. or do you mean i need a surge protector?

Joe Bone sounds like you need a new surge protector for just the printer. This happens a lot on normal printers and large current drawing devices

will have a look and sort one suprised as it printed fine last night but not today

Joe Bone is it plugged directly into the wall?

yeah directly into a mains socket.

Joe Bone GFI or regular?

Regular 3 pin outlet

Joe Bone ok then that shouldn't be it. Let's talk about temperature. You said it's in the garage. Does the power brick have a sufficient amount of airflow across it or is it buried behind a counter or something?

Sat on the counter behind not a huge amount of air flow but also bloody cold out there atm

Joe Bone so I would guess, either it's a fluke or a possibly bad power supply. If it's the power supply it'll start happening more often

Happened about 4 times today. Have given up for now until I got advice Haha. Will get looking for a new power supply was a secondhand photon anyway.

You waited a week! lol I had mine printing in like 30 minutes lol and I have not stopped lol I got mine about 2 weeks ago

It's a second hand one so wanted to check it over first and honestly was concerned it would break of something haha ? don't like how you can't see it printing. use to FDM printers haha

Joe Bone same here (I have 4 ender 3s) but you just have to wait.... listen for a popping sound on the first like 3 layers and you know it at least stuck to the bed lol but once you get going it's pretty easy! Clean up us a pain but printing its self is easier then FDM.

Joe Bone

Jolene Sweeney i have an ultrasonic cleaner i'm itching to try so hoping it'll be good. Also bulit a curinging booth into my garage shelf units ........ completely prepared haha

Joe Bone I built a curing area too lol I'm just using the pickle jar and acetone right now (can't get ipa lol) it's not terrible but I just got used to the print finishing and being done lol with sla you have to clean and cura and sometimes it just is annoying lol love my prints to!

Jolene Sweeney I was looking at all sorts for the cleaning I have some industrial degreaser which I'm going to try first and see if it works. Everyone raves about mean green but cant get it here. If the torture cube works then I have a second print lined up ready to go Haha

Joe Bone yea it's a pain right now. I tried mean green 1st and HATED it. It didnt clean my prints at all and then were tacky even after curing...

Apparently a cleaner like you have should help but I'm not going to buy one just because of an ipa shortage right now lol acetone works really really well so I'm happy til I can get ipa

Jolene Sweeney yeah I have it for cleaning up tools and bits anyway so it's easy to get and I normally have 5L sat about anyway

Joe Bone lol good thing! Well keep us updated! Hope the 1st print goes well!

Jolene Sweeney 40% complete give it an hour or so Haha