Hello everyone! Firstly, I 100% tried to use the search function. Second, I didn’t get the cube loaded to the memory stick, I got these strange things. Third, I scraped two plates off that were just flat, no extra greebles, I’m assuming there were supposed to be eight. That being said, am I having a leveling issue and need to retry, or is there something else? The two mess ups were only on one side. Also, there is a bit of a haze on my FEP. Super clean before hand, followed the Anycubic cleaning guide, and it seems off now and not clear.
翻譯年糕
John Bkly
2020-03-17 10:37:50
Yeah, these were on my memory stick too. Just got my Photon just over a week ago. Had similar issue where prints were sticking to FEP rather than the bed unless I releveled the bed prior to each use. I picked up the Sprectrum mobile app for my phone and tuned the FEP to around 330Hz and did a good print run yesterday without any issues after just leveling it once.
Vladimir Smith
2020-03-17 10:38:44
John Bkly
As in tightening the FEP? I have no issues releveling every time lol
John Bkly
2020-03-17 10:39:26
Yep, tightened the FEP and twanged it a few times while monitoring the results on the Spectrum app on my phone.
Vladimir Smith
2020-03-17 10:40:05
John Bkly
I had no idea you could do that. Guess I’m downloading that app now lol
John Bkly
2020-03-17 10:40:42
If you google it or look it up on Youtube, there are a few vids where they talk about it.
Vladimir Smith
2020-03-17 10:41:06
John Bkly
2020-03-17 10:42:26
