Hello you all,
Thank you for the admission to this group.
I am from the Netherlands and a happy user of a Anycubic Photon DLP printer, but have a problem, which started today.
Are there any Dutch users of Anycubic and also member of this group?
My problem: I set the printer to zero (normal procedure). Go to a certein hight, place the vat with resin and start a print. Building plate goes down, till the beep (it is now at zero, into the vat). First layer is printing and after the bottom exposure time the buildplate goes up (a certain way) and I hear the print coming loose from the FEP. Till here, everything goes normal.
But now the build plate should go down, for it's second bottom layer, but the plate goes up, a certain way, goes down and stops a few millimeters higher then it's zero-point. There my print goes wrong.
It seems like the software resets its zero-point.
When I interupt this print, remove the vat and push the button "home", it goes to home. I did not try to reset the print, so I don't know if the printer really lost it zero-point.
Does anyone knows what goes wrong and what I can do about it?
Thank you very much for your answers.
Fer Slenders
翻譯年糕
Aaron Wiggins
2019-09-29 04:05:21
Fer Slenders
2019-09-29 04:14:21
Danny Broekhuis
2019-09-29 05:27:48
Fer Slenders
2019-09-29 05:37:29
Tiernan Messmer
2019-09-29 23:57:42
Fer Slenders
2019-09-30 02:33:55
Fer Slenders
2019-10-03 02:13:57
Fer Slenders
2019-10-03 02:23:49
Fer Slenders
2019-10-03 02:24:12
