So I have an issue that has plagued a couple of prints causing a few failures but maybe you lovely people can help me cure it....... here is a pic of my settings and the problem....... it appears to be later separation????
Edit: resin is AnyCubic grey
翻譯年糕
Karol Bukowski
2020-03-28 22:22:03
Alicia Tarr
2020-03-28 22:23:03
Ether Quanta Deals
2020-03-28 22:28:27
Brian Rhodes
2020-03-28 22:30:02
Ether Quanta Deals
I’m calling it a plague because on the other print it was minor and fixable but this is just idk
Ether Quanta Deals
2020-03-28 22:43:36
Brian Rhodes
re-checked your supports, be sure the file is watertight, re-think about lift speed and lift distance.
Brian Rhodes
2020-03-28 22:48:58
Well here is today’s on the plate currently test. I changed some supports and it’s gotten further
Ether Quanta Deals
2020-03-28 22:56:35
Brian Rhodes
Sorry my english is not good. further good or not ?
Brian Rhodes
2020-03-28 23:02:08
Lance Englutt
2020-03-29 00:02:59
Still pretty new myself, but i'll take a crack at it. It's looking like you lifting and retraction speeds are a bit high. Also could be your orientation of the print to the plate that could be effecting it at those layers of the print.
Here's a pretty good link to explaining how orientation and lift speeds can effect prints.
https://www.instructables.com/....../5-Settings-to......
Brian Rhodes
2020-03-29 00:04:53
Well I believe I solved the issue with some better places supports. This model has been a pain due to such high detail and the fact I want it on my desk to look at when I’m done
Brian Rhodes
2020-03-29 03:26:23
Ok so here is the update as we near the final quarter of printing today.......the issue was poor support placement to hold the edge of the feet evenly. I used the defective print as a starting point to fix the supports up. Pictures will be added once it’s done
Brian Rhodes
2020-03-29 08:27:25
And here is the final result of the printing.
Brian Rhodes
2020-03-29 08:28:06
And after three days of fooling around we have
