Had a bad print tonight. As it was finishing I could see the UV light seemed to be messed up and so ran a test after cleaned up the resin tray. Indeed, the lamp was leaking light all around the rectangle and in random spots. This was strange because it was behaving normally right before the test. I powered the printer down, and restarted, ran the UV test again and things were back to normal. I have only had the printer a couple of weeks. Has anyone had this issue before? Is it normal for it to reset itself? Was this just a fluke?
翻譯年糕
Thomas Harrell
2020-03-30 07:20:02
Tim Moulton
2020-03-30 07:22:08
Look inside and make sure the cables are fully seated.
