Anycubic Photon Printer Owners 造訪社團

Hello Guys,
I’ve noticed this weird movement of the screw every time the platform goes up and down...is it normal? (The video is a slow motion video from two angles)
Thanks a lot!

翻譯年糕

I need help finding a part. This is the 'Acrylic Support Plate' for the Anycubic Photon. It the thick support plate that goes under the 2k masking screen.

This part appears to have gotten some resin on it and I can't get it off for the life of me. It's welded on there. I've soaked it in 99% isopropyl for days. I've scratched it a little trying to get the resin off. I need to replace it.

I have been unable to find a replacement part for this. Does anyone know where I can find one?

HELP!

翻譯年糕

Ok, need some help. Recently my prints have been failing. They just don't print. Small ones (like DND miniatures) usually print. But anything even slightly larger doesn't. There is always the first layer or two stuck to the build plate, and a layer or two stuck to the FEP. The resin I'm using is ELEGOO Green.

翻譯年糕

Guys, hello everyone.
Help me please. I have a Photon 2019 January release. (ordinary black)
On github.com I found gcode controls and printer settings. Here is the link https://github.com/…/firm…/factory-defaults-translated.gcode

My idea is to make an external driver for the Z axis, TMS2208 or LV8729 in 1/256 mode.

Question:

How do I configure this with the above gcode link?
I don't understand how to run these gcode in photon

翻譯年糕

Resin issues then vs now

翻譯年糕

Hey!!! I am trying to make the “ Open source hardware ring “ and keep ending up with something like this. Can someone tell me what am I doing wrong?! Why It keeps doing just half of it ?!

翻譯年糕

Struggling to load stl files into Anycubic Slicer from my laptop. Heard some graphics cards on Windows have compatabilty issues. Any ideas?

翻譯年糕

What's going on here. 2nd print of same part. Break away in different place. Positioned on plate in different spot.
Looks like piece has broken away but no thing left in vat?

翻譯年糕

I've seen a lot of people adding screen protectors to their Photons. Am I correct in assuming these are just for additional protection and they go on over top of the existing screen (right under the vat)?

Has anyone tried this screen protector from Banggood?

https://www.banggood.com/5_5-inch-2K-LS055R1SX03-Screen-Dis…

FEPShop shipping is prohibitively expensive :(

翻譯年糕

I’ve been having a problem with my supports failing. Then I noticed the arm moving and sticking. See video attached.
What can be my problem ? I reset the z axis already. Room is warm enough for resin. Put larger supports. And put it on an angle. Sliced in photon didn’t have problems with same print in photon before.

翻譯年糕