Anycubic Photon Printer Owners 造訪社團

This UI is pretty god damn sleek.

Now let’s test the printing ability...

翻譯年糕

HEY .. The new Chitu Software IS OUT :) WOOT.. It is Amazing.

翻譯年糕

OK, my LCD screen has finally kicked the bucket. The middle of the screen is letting light through. Question, I ordered a replacement screen about 6 months ago. Should it have the silver back? I had asked them to remove the back light, just want to make sure before I install it. Thanks.

翻譯年糕

If any one can help please guys. Iv installed a new screen after old one was not displaying anything any more, and UV test works perfectly now. When i try and print a design all i get is this image layer after layer. Iv updated the firmware and iv checked all cables.

翻譯年糕

Can anyone suggest me the optimum settings parameter for Skin color resin?

翻譯年糕

I have a few questions for this wonderful group :
Currently my printer is in my bedroom and i would like to install it on my balcony.

1- How is the resin reacting to day light ?
2- Should I avoid direct sun ray only ?
3- Can I open the bottle and pour the resin in the printer while indirect cloudy sky light hits the vat ?

I'm considering buying a garden furniture to stock the printer and print outside, obviously I need a UV proof one. But how's reacting the printer to low temperature 0-15°C ? For printing and storing ?

Thanks a lot

翻譯年糕

about to start first print, using chitubox, platform has this weird bowl shape, anyone know how I change that? want the flat minimal resin wasting platforms ive seen, thanks!

翻譯年糕

❤️

Hello,

I need some advice here.

I'm using the 3d monocure rapid gray, and did not managed to print successfully for now.

I've been able to print these model with the green that came with the printer.

Print settings are 10s, 0.050mm, 8 bottom layers 80s each.

As you can see on the picture, some supports failed to print.

Do you have an idea of what I'm doing wrong?

Thanks

翻譯年糕