Anycubic Photon Printer Owners 造訪社團

Reims by photon. Solid green resin.

翻譯年糕

Needs replacement?

翻譯年糕

Another fine print from Duncan Shadow

翻譯年糕

Hey guys, I need some help. My last print failed, due to supports not printing on couple of places. Raft is there, but supports didn't stick. What can be the issue? Used Wanhao clear 15/1/50/8 (settings from the table). Had couple of good prints before this one with the same resin and settings. Thanks!

翻譯年糕

Having issues with the bottom (closest to the plate) of the lacking detail. First I thought it was resin trapped by the supports, but it persists no matter how the supports are set.
I clean my prints with ipa and ultrasound before curing with a uv light, so that is not the issue. I've also had the problem with two different resins and I've stirred the vat between prints.
Could it be over or under exposure?
Here is the bottoms of my latest prints.

翻譯年糕

Help... The z rod doesn’t move the build plate anymore!

翻譯年糕

Last print of the weekend, done an handful of Duncan Louca's NPCs. Done with Monocure Rapid clear and Flex100. Have now some stuffs To paint this week.

翻譯年糕

Why does this happen on the top of the base?

翻譯年糕

I want to thank everyone that bared with me today. You all make my first day with my Photon a lot smoother. Still trying to get a good test print out. Im on the 3rd attempt. I thought the first one failed because i paused it at 8% to make sure it stuck. It did, but then the rest of the print was sticking to the vat. So i cleaned it all up and started again. Same issue. Stuck to both. Check my leveling and it was a tad to tight. I redid my home position and now the paper is loose with just light friction.

So here is hoping try #3 goes through smoothly.

Two last questions: How often do you all recommend replacing the sheet on the Vat?
Anycubic stated that you shouldn't leave the resin in the vat without printing for more that 48 hours. If i am printing continually, how often should i swap the resin? Or will it run out long before two day from continuous printing?

翻譯年糕

What would cause this? The front 3 printed perfectly but the back all failed ?

翻譯年糕