Anycubic Photon Printer Owners 造訪社團

so quick question, im still getting a little bit of a smell while printing even with my ventilation system. I thought i saw or read somewhere that if you cover the vents on the bottom of the printer and reverse that fan, that would be a great way to reduce the smell. But my question is how do i get access to that fan at the bottom? it looks like i need to remove the screen and vat and almost half way dismantle the whole printer, is that correct?

翻譯年糕

How many hours does it take for the build plate to be elevated enough to check and see if the print stuck to it or not? How many hours does it take for the build plate to be elevated enough to check and see if the print stuck to it or not? 翻譯年糕

Hey guys. I have had a few successful prints but now it seems like I have more and more supports failing(I assume, the mini ends up a disk in the vat) and some messed up layers parts that are flat and not supposed to be). I am using anycubic green at .02mm layer hieght. 7.5 normal exposure time. 1.5 off time. 40s bottom exposure time, and 8 bottom layers. Any advice?

翻譯年糕

Decided to give it a little paint, Model from Gambody and done with Vallejo Air and Citadel paint. Not a pro but i like it.

Gambody.com

翻譯年糕

The collection is getting bigger. Love this primer a friend got me, brush on army painter, the black sticks much better than the red one though. I'm having some problems tho, some of the lighter supports snap and produce some mistakes but haven't had a full failure, it probably is that the plate is a bit loose, gonna have to tighten some of the screws

翻譯年糕

Stopped using my photon for a while after being mad at it for the supports always failing when back at it today and still same thing lol wether I use b9 or the standard supports they almost always fail ? ? ? ? going to let this one finish anyway see what happens

翻譯年糕

Why is this happening? Massive split down side.
Process was
Open in anycubic slicer and resize 25% and save.
Open in mesh mixer and hollow with 2mm walls. These are obviously not 2mm walls.

This model has given nothing but grief. Is monocure resin too soft?

Do I need to add inside fill as per fdm.
If so how using mesmixer?

翻譯年糕

Is this paint acceptable for painting minis?

翻譯年糕

Finally have my Anycubic Photon up and fired. Next step would be to slice for DLP printing. Any advice is greatly appreciated. Thanks!

翻譯年糕

how essential is it for the FEP film to be free of scratches or marks? I find it difficult to clean the vat with the spatula without scratching the film. anyone have any advice about the best way to to clean the vat?

翻譯年糕