Anycubic Photon Printer Owners 造訪社團

Photon (maroon) and Phrozen (grey). Side by side Comparitive. I'd say pretty much the same. But. The grey is definately more photogenic.

翻譯年糕

Hello guys,
Does anyone had the setting for this casting resin?

翻譯年糕

plz help me .. to let me know the issue ?

翻譯年糕

After a lot of failures that used the majority of the starter resin I think I'm slowly getting the hang of the printer

翻譯年糕

Can anyone give me advice regarding finishing of a print? As in, I cure mine but tend to get some curling at the ends. Also, the surfaces don't seem to be as 'pristine' as they used to be, I assume the IPA has seen better days.

Anyway.... is it, print finished - clean off resin with water or IPA, then leave to cure (does length of time matter - as in if it cures quicker then less chance of deforming) then take off the supports?

Any advice as to methods would be appreciated.

翻譯年糕

first try 0.03mm with orange anycubic resin

翻譯年糕

So im strugglong with bed leveling right now. At first prints were only sticking to the right side of my build plate. I cleaned everything off lowered it to the lcd without the vat while the bed was loose, and tighted it. The mext print only the front of the bed had print adhesion. What strategy am i missing for leveling this thing?

翻譯年糕

8 hours and 17 minutes later, I have this monstrous Gargoyle.
Standing at 120mm.
With .07 layers.

翻譯年糕

Does anyone know if a golden resin exists?

Thanks! Does anyone know if a golden resin exists?

Thanks! 翻譯年糕

This detail is pretty crazy ? only a few weird looking beams in the tiny Windows, but i Think those Bent when shaking in IPA...
Printed flat on bed with anycubic green resin just for fun.

Now people say 1-2 min in IPA, but with something this detailed there is always a little drops of uncured resin here and there after IPA, do you just let that cure? It seems like it doesnt Sun cure

翻譯年糕