Anycubic Photon Printer Owners 造訪社團

Printer has almost been plug-n-play easy to use so far, I am so amazed, never 3D printed before and at my 7th print without any failures! I bet i just jinxed myself, but that Jabba is worth sharing ?

翻譯年糕

3d printed upgrade parts ? I am working on a short project (and video) restoring a 1/65 diecast tractor from my childhood. I never liked its wheels so after an hour of 3d modeling and a couple hours of 3d printing on my Photon I have a set of new wheels! ?

翻譯年糕

Can you guys post some pictures of the most intricate things you have cast using this printer?

翻譯年糕

Maroon. 0.03, 14s, 10 @ 100. Not bad, can drop exposure some more I think. Photon been printing super clean since the last tear apart.

翻譯年糕

Wahooo, my “random reward resin” arrived. Will be fun to try out the red Anycubic. Thanks again for the prize. Now... what to print, what to print?

翻譯年糕

are there two different models of the Anycubic Photon?

here is why I ask.

I might be remembering this wrong. but I swear my first Photon the Z rod was attached to a block at the top.

my new photon that arrived today, the z rod goes up and just stops in mid air.

maybe i'm confused and imaging things.. but I swear my first one had a block at the top of the z rod that the z rod went into.

翻譯年糕

Gonna be so glad when the new slicer software comes out for the Photon...i've been slicing these arms for almost 20 min now...the body that these arms attach to took way less time to slice lol.

翻譯年糕

Well well the new printer arrived. I got everything installed and the bed plate level. Everything appears to be okay all of the screws or tighten down really well. I went ahead and load it up its first print. To immediate things I noticed. The bed is quieter when running up and down the Z screw. And when the bed pulls up off the fep, now it makes more of a crisp cracking sound, rather than before it almost made a dull thud like a drum. I guess after work we'll see if it makes a difference and prints better

翻譯年糕

Hi all. Ok so I need some help. Out of the box worked great for about a week. I am using a 3rd party white resin and have gotten good results. Yesterday had a partial fail where the print shifted about 20mm to the left.
Next print completed but only half of object was printed. A clean horizontal cur about 45mm high.
Next print it only made about 20mm
Then nothing at all.
I am printing the same item a few times.
There is no residue on the fem film. And adhesion is not a problem.
I see no blemishes on fem film.
No error codes.
I watched the screen and it seems to be displaying the imiges.
So I'm lost??

翻譯年糕

HELP!!!!

I'm using funtodo next gen snow white, at .04, 12, 1, 80, 8

And I had 8 of these pillars, the corner one failed during the support stage, the rest printed but had some weird issues but none were consistent on each pillar some were okay some had issue A some had issue B some had both...

The bottom or where it meets the support on some had layer separation on one side at the base and for issue B, the last few layers on some of them got stuck to the bottom...

翻譯年糕