Anycubic Photon Printer Owners 造訪社團

Hola, una consulta. Tengo una Anycubic Photon recién estrenada y en la impresión de prueba ha salido mal. En la ultima parte de la impresión la plataforma no se movía. He vuelto a calibrar y estoy imprimiendo de nuevo. Pero noto que cuando sube la plataforma para hacer una nueva capa el objeto se queda pegado al fondo, aunque acaba despegandose del fondo. ¿Que puede ser debido? ¿mala calibración? ¿z=0 demasiado bajo?
La imagen es el resultado de la primera impresion.

翻譯年糕

hello, sound came when the platform came down, someone had such a problem, or do you have any idea of ​​what might have happened?

翻譯年糕

Any of you print toy car tyres? What resin? Show some pics please. Thx

翻譯年糕

How could i make something like this? I tried making a hole in a cube, but it printed solid like if nothing was there

翻譯年糕

Make take on the 3 Wise Skulls
grey/white base. dirt brown ground and black acrylic wash

翻譯年糕

Fatman and little boy

翻譯年糕

Is there a good step by step tutorial out there with basic principles on how to place your models in the slicing software? I read that you should (always?) place the model at an angle and hold it with supports. Ist that right? (so no placing the base directly on the plate)

Just to give an example: How would you place and support the chess piece from this link: http://www.monocure3d.com.au/CALIBRATION-MODELS-s/137.htm (fourth from above)

Any kind of help is greatly appreciated. I am completely new to resin and 3d printing as a whole and am a little bit intimidated tbh.

Thank you!

翻譯年糕

Hey Everyone. Using monocure rapid clear with 50sec bottom layers (15) and 12sec normal with 1sec off. Most my prints are fine, but some are being ripped off their supports. I notice when printing, I can hear the print peeling off as if it is stuck to the FEP sheet too much.

Anyone know a way to reduce it's grip to the FEP? Higher/lower exposure times?

翻譯年糕

Is it ok to leave a finished print in the machine overnight? I have a print that is ending in the middle of the night and I’d rather not wake up to clean and cure the print.

翻譯年糕