Anycubic Photon Printer Owners 造訪社團

Is this laptop efficient to run programs for this 3-D printer

翻譯年糕

Hi Guys,

Have people knows how to change the speed of the Z-axis as it move up and down setting ?

Due to we want to print the sample object model , have many area can not print finish.

My personal feeling is that the current Z-axis as it move up and down speed is too fast.

Can help me to clearly my question ?

Many Thanks.

===========================================
Update : 20180922

我終於看懂
https://raw.githubusercontent.com/…/resin-…/print-mode.gcode

這裡面的設定資訊.

1.
控制首層的抬升距離 使用 M8070 S3
控制首層的抬升速度 使用 M8015 T2

2.
控制剝離抬升的距離 使用 M8070 Z6
控制剝離的抬升速 使用 M8016 T3

Philippe Maegerman

These lines are for the speed T1 is slower, T2 faster, T3, T4 etc ...
then you save and you print this file, it will update the firmware

;(Peel and lift speeds)
;M8015 T2
; Initial peel speed slow move
;
;M8016 T3
; Build plate raise and lower speeds between layers

Vinicius Silva

Many thanks for provide help for me guys.

翻譯年糕

totally losing faith in the photon and its support. time for a change i think.

翻譯年糕

Stupid question guys...do you remove supports before or after UV/light bath?

翻譯年糕

try lifting this 'resin' around

翻譯年糕

where to buy lcd also the glass in usa ?

翻譯年糕

how many rings will fit on this printer anyone know? I have a large order I need to get done!

翻譯年糕

So a question wrt translucent vs. opaque resins. Has anyone noticed losing detail on the part of the print facing the plate when using translucent resins? I'm trying to print some parts that have a lot of detail on every surface (a Mech model) using a translucent blue filament. The detail on the sides and side facing away from the plate are fantastic, but the side facing the plate loses detail, and the support is sticking much harder to that side than anyplace else. I'm wondering if UV light is bleeding through the translucent print and hardening resin pooling on the top. Is this a realistic concern? Would I be better off with an opaque resin for this use case?

翻譯年糕

Hello everyone.
I've had someone recently ask me to do some custom work, but I'm not sure what to charge. Any suggestions on how to figure a price? Hello everyone.
I've had someone recently ask me to do some custom work, but I'm not sure what to charge. Any suggestions on how to figure a price? 翻譯年糕

Hi guys. Is this an unsafe amount of resin for printing? I suppose I need to loosen up the plate and clean it up after this. Also what I'm printing. Part 1 of 2 of my 6 inch Golden Frieza.

翻譯年糕