Anycubic Photon Printer Owners 造訪社團

Thats rare i do bust but this one looks good.
Monocure Rapid Gunmetal
50um
13sec/layer

翻譯年糕

Hello everyone. I got my anycubic photon last Friday and I managed to get some awesome prints, but now I'm dealing with some problems. The pieces get separated from the supports, either completely or some parts.

I'm using anycubic green with 50s 8 base layers and 10s 0.05 normal layers. Could it be the curing time for normal layers is too low?
The image of the successful miniature was if I remember correctly at 0.025 layer height and was printed with the base parallel to the plate (I know bad, but it worked). I would really appreciate some help in troubleshooting this

翻譯年糕

New FEP is in, and print attempt number 3 is underway. I have:

1. Re-levelled without Flint by using the paper and the "able to pull but not push" methodology
2. Re-done my model without automatic supports and did manual ones in B9 as suggested by Nick Williams in his videos
3. Re-oriented it to suit all previous recommendations
4. Checked my print settings matched the group spreadsheet recommendations
5. Made sure I shook the resin first pre-print

and...

I can already see only 140 layers in that it's already not sticking to the build plate again.

To say that I'm becoming agitated is an understatement...

翻譯年糕

I just received my Photon and am prepping my first file to print. I oriented the part at 45° and it just seems like there's not a lot of auto-support being generated (since the support angle is also 45°). If this was a print on my FDM I'd be worried. Should I readjust the angle to 50°? Here you can see the one in the rear is generating at an angle of 50°, the front is the default 45°.

翻譯年糕

I think i do vent hole wrong for all of the time. Any video to show proper way to put vent hole ? ( Not drain hole ) Thanks in advance

翻譯年糕

Hello fellas
What would cause these lines? Is there something wrong with my z rod?

翻譯年糕

I've recently bought this printer and the first print I tried came out pretty good (minus losing a hand due to supports) but all prints I try now have got these strange lines in them. I've replaced the film and I'm still getting the lines. I'm using anycubic green resin. Any ideas on how to solve this?

翻譯年糕

I stripped the small hex screws used to tighten fep. 2 of them ? . Any tips on how to unscrew them and what are their sizes so I can get replacement?

翻譯年糕

Not perfect and haven't sanded supports yet, slightly primed. Very happy with the details though! Metal Slug tank

翻譯年糕