Anycubic Photon Printer Owners 造訪社團

Hi, this is my first post. Been using the machine for two weeks now, had great results with the included resin but I recently changed to Monocure Fast Clear, have tried the settings on the public doc, but I’m still having issues. I get lines and weird bumps on the bottom of the print, and the defects clear up the further the print goes, so what could be causing this? Any help will be appreciated!

翻譯年糕

I'll be honest, they're pretty bad prints, but I'm in love with them. Pumping out tiny model tanks on demand is a childhood dream.

翻譯年糕

Printing this...
Latest F360 Model here: https://a360.co/2zlD9I8

Older Version: https://a360.co/2xwk2sP

翻譯年糕

Finally getting success with my photon, I swapped over to the grey from the maroon and it’s been smooth sailing since I am so impressed with the details this little machine can do

翻譯年糕

So after stinking house up I added a 4inch fan and carbon filter. It's still stinking the garage up thank God not the house. Do I have a defective proton or does it just stink and most of you can't smell.its not the resin smell though it's like a generator/ gocart .thanks .hope my trubbles gives someone a laugh but this stinks. Also have second fan moving air to window and a ozon despncer going

翻譯年糕

Has anyone used this one?
Any particular tips&tricks?
Tks

翻譯年糕

Is this good for cleaning models and printer?

翻譯年糕

Loving this little printer..
First attempt at airbrushing

翻譯年糕

https://youtu.be/3edBQrolU-o

https://youtu.be/KdC4nVqHVkA

A short set of videos to show you how to manually support. This model was sent to me by Javier Barbero ! Javier, if you have trouble resetting the angle to print flat against the plate, send me the .stl instead of the .mix!

翻譯年糕

Suggestions? My horizontal layers do this. And if I use support they do the second photo

翻譯年糕