Anycubic Photon Printer Owners 造訪社團

First layer stays for a very short time, I did not slice it that way... is this a printer or a slicer issue ?

翻譯年糕

My first print. Is good?

翻譯年糕

It's worth what it's worth but my tip for removing supports is to let the print under hot water for a minute, they become very soft and snap super easily, then I sand before UV curing while it's still soft, I have started using Tamiya sand sponges, they are great for organic models, you can cut them in small pieces to reach those tiny corners.

翻譯年糕

The Miner.

翻譯年糕

For those who need settings for anycubic maroon.
Works for me.

16exposure, 6.5 off time (more accurate time and firmware does not accept eny changes if its lower than 6-6.5) 90 pase layer and 10 pase layers
0.05 layer hight

翻譯年糕

I just went through the files section while looking for the resin settings spreadsheet. Has it been reloccated, renamed, or am I looking in the wrong place? Thanks in advance.

翻譯年糕

Just got it
Did my first print yesterday

Very good first impression with it :)

翻譯年糕

I still have some issue with my printer, I posted the UV detection bug where the screen doesnt work the second time.
Now I have some issue with files I sliced myself, on one the first picture appears for 1 or 2 seconds (instead of the base first layer) and then the screen goes black. On an other the first layer appears (for the right amout of time) and then nothing, and on others everything goes right.

Could the problem come from the sliced files or is it the printer ?

翻譯年糕

Sssssskull, first time I'm paying for a model, it's really worth it, very good quality ;)
phrozen resin @ .025
https://www.cgtrader.com/3d-print-models/…/skull-with-snakes

翻譯年糕

Can you pause a print, move the z and resume. Want to check if it's sticking. Last print was running for 4 hours and I noticed it didn't stick. My first print stuck, but failed (not sanded and it stuck) . I have since updated the firmware and redid my zero.

翻譯年糕