Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Anybody tried the anycubic plant based resin yet? With all the people talking about how bad the normal resin is for you and the smell, I assume this is going to be pretty popular here. The question is, does it actually work correctly and cure right compared to the "non diet" resin. :)

If anybody has tested it I'd like to know how it compares.

翻譯年糕

Is anybody else hesitant to do a firmware update when they release the anti aliasing version from concerns of it starting lots of other problems? I've seen too many people here have major issues after a firmware update.

翻譯年糕

Will letting resin sit in a vat for, let's say a month, cause it to eventually leak in anyone's experience?

翻譯年糕

Does anyone know (possibly from having tried) if resin can be used on hot wax to make a wax stamp/seal? The way that they sealed letters back in the day? I know they usually use metal but I'm curious whether the resin would release from the wax the same way the metal would or not.

Might be printing one soon to try out but didn't want to waste the time if anyone had tried already and it failed.

翻譯年糕

So I've been hearing about this new chitu box and wondering about it. Anyone who has tried it, tell me is it much better than the photon slicer and should I just use that instead? Better supports, better slicing, etc? Sell me on it :)

翻譯年糕

So I did my test print of the free Hero Forge model that I was asking about a few days back. All in all I think it went pretty well except for some weirdness on the back bottom part of the jacket for some unknown reason...maybe it needed more supports there but it sort of flattened out.

Primed with vellejo surface primer (which I hate and need a good replacement for that isn't awful to clean) and an airbrush. Missed a few support cleanup spots but it's as far as I'm gonna go on this test print, I'll do better if I do a full print later.

Printed at 0.05, 5.5 exposure, 6.5 off time, 70, 8 with anycubic green.

翻譯年糕

Question to you guys about updating firmware. I still have the original firmware and haven't had an issue yet. The going opinion was to not update it EVER unless there was some absolutely necessary reason to.

With some printers and software like cura, you have to update the firmware if you upgrade the slicer to a newer version.. otherwise things won't work properly. I haven't updated my slicer from 1.3.3 to the latest 1.3.6.

Just wondering if I am ok to do that with the original firmware without creating any issues for myself. Thanks.

翻譯年糕

Hey guys, quick question about File Validator. Has anyone done a successful print without using file validator, then ran that .photon file through validator after and found it was riddled with unsupported islands?

I just ran my first print that went perfectly through it and found that to be the case and it confused me.

翻譯年糕

Hey all... Just wanted to know if hero forge figures are known to print well on the photon? I know ppl here have printed them. Would like to know your experience and maybe see some photos of unpainted hero forge characters if you want to share. Thanks.

翻譯年糕

So, it's been a while since I had last looked but it seems like Anycubic has lowered the price of their 500g of resin twice on Amazon. From $50 to $45 and now $41. Anybody know if that is just a sale or just the new retail price?

Good to see resin prices going down I hope it's permanent and will continue just like filament prices.

翻譯年糕