Anycubic Photon Printer Owners 造訪社團

Is this a leaking FEP? ? ?

Might give some more info ?

The wet spots appeared after I touched the FEP through the resin. When the VAT is installed there is nothing to see.. ?

翻譯年糕

SCAMMER ALERT.

David Rivera has faked selling me a Wanhao D7 (and D7 box) and appears to have run away with my money. This occurred in this group.

I have asked him, several times of the past few days, what the status of our deal is, with no response. Feel free to read the conversation, all is included.

David Rivera, expect a paypal dispute shortly after this is posted.

翻譯年糕

I haven't purchased a printer yet as I am looking a the various model available however I see a lot of 'mis-prints' problems here .I was wondering..if the printer itself is not perfectly level on the table it's sitting on, or if it picks up any vibration from the table while printing would that effect the prints?

翻譯年糕

https://zortrax.com/3d-printers/inkspire/

Well Zortrax finally entered the market. This thing is going to be expensive and not even be much better than the cheaper alternatives.

翻譯年糕

Hello guys!! Can someone help me? You have to do the test printing or I can already make pieces that I want. Hello guys!! Can someone help me? You have to do the test printing or I can already make pieces that I want. 翻譯年糕

Hello there! I'm thinking about purchasing Photon for jewelry and dental purposes. I saw that dental things is real for this printer, but have some doubt about jewelry.
Is here anyone who had real experience in printing jewelry castable models? Any information would be nice.

翻譯年糕

What is the consensus for best resin for detailed prints at 0.02mm (or 0.025mm) layers?

翻譯年糕

So my new motherboard is on it's way... I have to say, so far I'm fairly impressed with Anycubic's support. Fingers crossed this is the magic. ? ? ? ?

翻譯年糕

Is this too close to the edges?? This is part of my first big print and I'm not sure how much wiggle room the slicer has

翻譯年糕

Always amazing results with monocure grey!

翻譯年糕