Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Alexandre Castilho
2020-03-24 07:56:03

Hey there. Quick question can we print at 155mm high without modifications?

Christopher Fugate
2020-03-24 08:13:10

It's listed as buildable to that height, but you'd be seriously pushing the limits, and anything right at the edge like that is iffy. Could work, might not. Could vary based on print or even temperature.

Alexandre Castilho
2020-03-24 16:46:48

You think that height already accounts for peal motion?

原文網址 Alexandre Castilho
2020-03-21 19:26:15

Hey there. Some time ago I saw a post about the compatibility between chitu versions and firmware versions, but can't seem to find it. Would someone be so kind to direct me there?

翻譯年糕

原文網址 Alexandre Castilho
2019-04-09 22:43:34

Has anyone tried Ferrolite resin?

翻譯年糕

Adam Fitzgerald
2019-04-09 22:46:49

原文網址 Alexandre Castilho
2019-02-10 01:02:11

Hey there fellow photonsters! Is there anyway to raise the the z=0 without having to level again? I mean, I have it leveled, but feel it's too low and wanted to raise it up a bit 0,01 or 0,02.

翻譯年糕

Zena Andreou
2019-02-10 01:32:41

Alexandre Castilho
2019-02-10 02:10:15

Zena Andreou
2019-02-10 02:12:44

Alexandre Castilho
2019-02-10 02:39:15

Alexandre Castilho
2019-02-10 02:40:53

原文網址 Alexandre Castilho
2018-10-07 18:03:32

3 prints with the plate full. One more to go to have it finished. 28mm 40k Rhino (my design inspired by Closeau's)

FunToDo Industrial unpigmented at 0.025mm layers

翻譯年糕

原文網址 Alexandre Castilho
2018-09-13 21:41:48

What is the consensus for best resin for detailed prints at 0.02mm (or 0.025mm) layers?

翻譯年糕

Alexandre Castilho
2018-09-15 02:48:19

原文網址 Alexandre Castilho
2018-09-11 02:13:43

Little help interpreting these please.
So, 1st picture is the Exposure test for 0.025mm. I figure between 3 and 4, Right?
Second picture is at 7s To right corner isn't really well defined. Am I over or under?

翻譯年糕