Anycubic Photon Printer Owners 造訪社團

In my travels of the web I seen somewhere but don't remember where a slicer software that gives you about how much resin you would use for the print or have I lost my mind again for some reason I think it was perform or prefab something like that

翻譯年糕

For anyone not using Resinaway and having whitening problems; I tried this a couple of time, must have a common ingredient with Resinaway. Just on black Anycubic resin. If anyone can try it on translucent resin would be nice.

翻譯年糕

Print bed. Why not a few extra mm in size. Every little bit of realestate counts.
Looks to me like there is room to grow. Print bed. Why not a few extra mm in size. Every little bit of realestate counts.
Looks to me like there is room to grow. 翻譯年糕

can’t figure out why my prints are coming out like this. the bottom part of the heart is not forming, supports not are not forming on that one side.

翻譯年糕

Just got my printer today. I unboxed it set everything up plugged it in and turned it on. When I plugged the usb in and went to print it came up with all the software and everything on the usb. So I pulled it out and plugged it into my computer downloaded the slicer software pulled up a file onto it but then everything glitches out when I tried to save it and my computer screen we t blue so I restarted my computer and when I turned it back on the flash drive isn’t recognized and when I plug it into the printer all the files on it don’t show up any more. Along with that when I try to save a file to any other usb drive I have when I plug it into the printer nothing shows up, Ik it’s saving to the usb tho cause I can pull it up on my computer. Please help, if anyone else has experienced this problem let me know how you fixed it.

翻譯年糕

Where can I find a lcd
screen replacement in the usa

翻譯年糕

Has anyone purchased FEP from fep-film.com or Linatex.dk and care to share their findings about the quality of these two? I see that they are dirty cheap compared to anycubics etc

翻譯年糕

Does anyone have a good source for any cubic resin specifically green and red now that makermarket closed?

翻譯年糕

A week or two ago we made a poll regarding sanding the build plate and from that came to the conclusion that it's flatness not surface finish that is the issue. So now I'd like to talk about curing prints. Some feel water is resulting in whitening of print surface. Others cure the print underwater. Let's put this to bed, how do you cure your prints, have you had whitening and what do you think caused it.

翻譯年糕

My first good print (appart from the cube), I am in love XD

翻譯年糕