Anycubic Photon Printer Owners 造訪社團

Hello everyone. I want to print this piece of a bigger project. I have hollowed with Asura 1.5 and make 2 drain holes. The question is, I have 1 centimeter tall of resin in the vat. It is enough resin for this print? Is big, but kind of thin, and is partially hollow. The leftover is anycubic green, but I have another litre of Anycubic blue. Shall I mix it?

翻譯年糕

Some great printa with anycubic photon and bluecast!!!!

翻譯年糕

I'm getting some peeling on the last layer. Any ideas? Thanks. I'm getting some peeling on the last layer. Any ideas? Thanks. 翻譯年糕

What's on your plate this Sunday? ? It took 9 hours.

翻譯年糕

My latest print and paint

翻譯年糕

Goup, I'm getting a bit frustrated.
First 2 Pictures where my first aatempt (0,02). Since it failed I tried again with 0,05 Layer thickness, using the numbers from the spread sheet (Monocure Rapid Clear):
norm. exp.: 1, Bottom 40. Bottom Layers 10. As you can see in the latter pictures, it still failed. Last pic is how it SHOULD look. I'd rather use 0,02 than 0,05, but I can't get anything to work anymore :-(
Can you please help me adjust my settings?

翻譯年糕

My Photon just arrived.

翻譯年糕

Hey guys,
My printer arrives later this morning so I'm doing lots and lots of watching and reading in advance to make sure I give it the best start. One of the things I've watched is this:
Completely dismantling the unit straight out of the gate seems like significant overkill, but the unit shown is the new one without the top Z-axis being fixed, so I have this question:
Is this something you guys have done? Is it necessary / advised?

翻譯年糕