Anycubic Photon Printer Owners 造訪社團

Hey guys , Quick question if i Hallow a model for printing do i have to use supports inside the hallow or are the outside supports enough ?

翻譯年糕

Short question...

How can i get the model sliced flat on the platform?
I get a z offset automatically?!
Like the photon cube, the diameter is flat on the platform too?!

翻譯年糕

Using other than the USB that came with the Photon?
I just tried a dirrent stick and the machine basically shutdown. Power on but no button would work. Put in the Anycubic USB and all good again?

翻譯年糕

Anyone know if this is caused by under curing? Monocure rapid grey. My guess is the model is still soft and stretching each time it is lifted from FEP.

翻譯年糕

Can i leave resin in the printer for 14 hours?

翻譯年糕

Had this machine for a week now, wow, I love it! It prints great! The smell of resin was permeating throughout my house, it wasn’t too bad, but was certainly there. Then last night I tried Monocure Rapid clear, wow, no smell whatsoever!!
Clear prints great! Just wondering if anyone has any tips to keep it clear. After printing I placed into an US bath with resin away for 3 - 4 minutes, then placed under my UV nail lamp, it was looking great. Then after a while I rinsed under water and it went cloudy, not too bad, but looked fantastic before the rinse.

翻譯年糕

Waiting 9 hours to finish. :D

翻譯年糕

I have been printing my 28mm D&D minis flat to the base because the few times I tried 45 degrees they would fail.

Had to change the fep because of a hole in it last night, and thought I would try again.

Success! Hurray!

翻譯年糕

Hi, i'm new here, just want to know what app do you use to design 3d printing object? Hi, i'm new here, just want to know what app do you use to design 3d printing object? 翻譯年糕

The Three Wise Skulls printed with no supports
15hrs. I found tilting saved minimum.

翻譯年糕