Anycubic Photon Printer Owners 造訪社團

Hey guys, 8 hours later, here is my first print. I have not fully cured it.

Does that look like z wobble to you?

When I got the printer I had to put it on the track and I adjusted it for tightest tolerances then. It looked like the carriage was wobbling some dieing printing, but I was hoping my eyes were deceiving me.

翻譯年糕

Beerus the GoD, model from Gambody.
Monocure Gunmetal resin.
50um.

翻譯年糕

Any wanhao red resin uses here? Curious what settings you have had the best results with. Still learning :D

翻譯年糕

Tried. This resin from monoprice n it don’t print at all here’s my settings on the photon slicer

翻譯年糕

Gave up on trying to print it, just milled it instead.

翻譯年糕

Hi,
If someone could please help me to identify what software is being used to display these designs?

翻譯年糕

Contrats guys, good job to everyones.

https://m.facebook.com/groups/174880113167057?view=permalink&id=250536348934766

翻譯年糕

https://youtu.be/TIR0AISivF0

An over night failure.
Half way through a 15 hour print it decided to stick to the FEP.
Why? Was only doing 2mm outlines. Nothing hard to lift.
Stuck good to the build plate though

翻譯年糕

Primed. Doesn't look bad.

翻譯年糕