Anycubic Photon Printer Owners 造訪社團

New batch of parts printed overnight.

翻譯年糕

I printed these star fighter wargaming miniatures for a friend. Since I’ve had far more success with the green resin than the black, I think I’ll stick to that.

翻譯年糕

What is everyone else using for Monocure Rapid 3D Clear resin? The spreadsheet settings did not work for me.

翻譯年糕

Looks like Aliexpress is going to have a sale on the Anycubic Photon. The sale is in 7 days but if I understood it right you can pre-order it now by putting down a deposit. I don't know why they are doing it this way, maybe there is a limited amount of units they have for sale. I'm able to get if for $392 shipped to Norway and that is almost $200 less than the best offer I was able to find a week ago.

Disclaimer: I'm not associated with Aliexpress in anyway. I've bought a bunch of stuff from their site and I've always gotten what I've ordered after the standard china shipping time of 2-6 weeks. I've never returned or complained about anything I bought from them because I've never bought anything that's been expensive enough for me to waste my time getting a refund. I don't know what kind of support you will get. If this is a problem for you, I'm sure you are better off ordering from Amazon or something like that.

The link:
https://www.aliexpress.com/…/ANYCUBIC-Pho…/32877785341.html…

翻譯年糕

Just wondering are any of the monocure rapid resins translucent besides the clear of course lol Just wondering are any of the monocure rapid resins translucent besides the clear of course lol 翻譯年糕

Ok, quick question, I've adjusted my z carraige for the third time to try to eliminate z- wobble and it seemed pretty tight, no play in any direction, now that I've re-assembled and attached the build plate there's now quite a lot of play back and forth and side to side.
Can anyone check to see if this is normal or should it be rock solid if you try to move it bt the build plate?

翻譯年糕

..playing with it...

翻譯年糕

This grid works VERY well for adhesion fyi. No loss of parts from the table is 3 prints now. The "solid" seems weaker somehow and parts simply fall off of it. (Last two images.)

翻譯年糕

Hi, so excited to have successfully printed the test cube on my new photon (print was fine but I learned a thing or two about cleanup!). Started looking at other things to print and that got me wondering about how much resin these prints use. I'm told the wanhao D7 slicer estimates resin quantity but can't seem to see anything similar in the anycubic slicer. Anyone know of a way to estimate how much resin a print is going to need?

翻譯年糕

I am about to get my printer tomorrow. Already bought gloves, mask, IPA, and UV light are there any other items that I should buy? Also are their any suggestions you have for starting off. GO

翻譯年糕