Anycubic Photon Printer Owners 造訪社團

原文網址 Maggie Jenner-Bennett
2018-08-09 20:14:09

I had a print fail due to large flat surfaces, so I realigned the objects and reprinted. I guess I was tired and didn't think to check how much resin was in the vat...everything printed fine! Love this little printer.

翻譯年糕

原文網址 Six Hatch
2018-08-09 19:19:04

Hi, does anyone have a fix for this issue ? My printer is like 3 days old and already dead. My unit has yellow windows and the power supply sticker has green text.

Having the exact issue as this guy in the video except I did not see any error codes. The printer just restarts after trying to print.

https://youtu.be/ZzRGpBxhopo?t=153 . It finished a really good print just before...

updated the firmware too..
nothing changed.

翻譯年糕

原文網址 Thanh M. Vu
2018-08-09 19:15:28

Hi all, I'm about to do a setup for the first time and I just wanted to get a checklist going to make sure I have everything correct:

1) Apply Rainx to FEP, let dry
2) Level printer
3) Tape down the LCD screen, as recommended by AnyCubic
4) Should I download the latest firmware flash? I heard some people were having troubles with firmware updates (ANYCUBIC Photon Firmware_V1.1_201807)
5) Download slicer
6) Download Bo Norgaard's Photonster validator
7) Finally start printing

Anything I should add or watch out for?

翻譯年糕

原文網址 Nick Walker
2018-08-09 19:04:28

I'm getting a deformed look on the support side of these models facing the build plate. Is this over curing? Monocure rapid clear 0.02, 9, 6.5, 85, 4.

翻譯年糕

原文網址 Mark Toolin
2018-08-09 18:54:50

Noticed a few lines in the print, wonder if it’s because I paused the print.

翻譯年糕

原文網址 Amy Liao
2018-08-09 18:37:27

A privilege for our new members.

Welcome. ? ?
http://www.anycubic3d.com/index.html

翻譯年糕

原文網址 Gargantux Doe
2018-08-09 18:21:05

Calibration issues here.

So after running out of anycubic green default resin shipped with the printer, I wanted to try the anycubic black.

I tried to print the calibration model resin-test-50u.B100.2-20.photon
3 times...

Each time, I end up with a nice flat black piece of resin, and nothing. For 2 times, I got the pattern on the plastic film of the tank.
See pictures.

I need to mention I did bed levelling each time before printing (the a4 paper method => put the paper, goes to 0, then go down until I could pull the paper with a bit of tension, but not push back).
I also let the resin rest for 30min, and each time used new resin from the bottle (not the previous one filtered).

During the 3rd print, I stayed in front of the printer (it's only 14 layers ;) ). I could hear some "pop" sound, when the bed was going up, so probably when the resin was unpoping itself from the plastic film of the tank.