Anycubic Photon Printer Owners 造訪社團

So much love with this machine

翻譯年糕

Anyone have experience with HARZ resins? Good or bad?

翻譯年糕

First print! I'm not sure if the lines qualify as 'banding', or are you always going to expect some of this? The middle of the model is hollow, and no weep holes, so is that why it blobbed up towards the bottom? Printed at 45 degree w auto supports on the back. Next test I will add holes at bottom and flipped so it drains.

Was going to share slice pic, but the photon file doesnt load back up in slicer. Is this normal? It show me the slices but doesnt display the model and supports. Do I need to save the stl w supports each time?

翻譯年糕

Hi everyone. Does anyone know how to solve this in Meshmixer? the tips of the supports do not enter completely. How can I make them have more contact? I think this is my problem with the tips of the supports in printing. Thanks!

翻譯年糕

Hi Guys, I just updated the photonsters troubleshooting guide for people have memory errors / random resets. https://github.com/…/an…/blob/master/photon-common-issues.md

Random resets / Memory errors / USB Read problems
Symptoms
Printing freezes at random points, resets to homescreen
Random freezes with error code
File browser not displaying any models
USB key light indicator is off, but plugged in ( it should always be on )
If you wiggle the USB Key, you can read files again
How to fix
replace stock USB key with >16gb one, format to Fat32
Only have one file on USB, using short name and no non english characters or spaces.
If problem still occurring you might have defective USB extension cable or faulty mainboard.
Test with a new USB Extension cable. this is male to female type, you can easily access this by removing the four screws holding the rear vent. UNPLUG POWER BEFORE DOING THIS Unplug the male connector to the mainboard and plug in a replacement, then plug in your USB key. If this fixes the problem, contact Anycubic for a replacement cable as it uses a special external mount.
If you have a small USB key, you can plug it directly to the mainboard for testing, I would not recommend it as permanent solution.
If the problem does not solve with replacement USB cable, then you might have a faulty mainboard. Contact Anycubic immediately for a replacement or new machine. Firmware updates will not solve the USB issue.

翻譯年糕

I've seen very nice prints done with phrozen grey resin

翻譯年糕

Ok..Going small with Monocure Rapid gray is a win! 15mm figures found on Thingiverse, settings posted on spreadsheet.

翻譯年糕

Diamond from Thingiverse. Printed on Monocure Clear, 0.5/60/8/10/1. No polishing, sprayed with clear coat. Left overnight unprotected, caused a little yellowing.

翻譯年糕

Test printing my new miniature design on my photon now. Will need it as my group will end up running into a certain Demon Queen of Spiders... Thought?

翻譯年糕

printed these little castle tops. I haven't taken the supports off yet. Not sure if I left under the UV lights long enough or too long. I think I clean them, ok though. Is there a way to tell? I have some UV Nail thing I purchased. with 30 minute timer. I just keep pressing for few hours.

翻譯年糕