Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Bryan Bellerjeau
2018-11-28 01:18:55

I have my Photon in the garage. No issues printing in the heat, but seems nothing will stick to the plate in the cold. Is that an issue for others? I'm in Cincinnati, outside temp in the 20s today...

翻譯年糕

Giancarlo Arriola
2018-11-28 01:22:30

Jason Pook
2018-11-28 01:27:03

Jason Setzer
2018-11-28 01:35:08

Rob A Wax
2018-11-28 01:41:07

Dave Corbett
2018-11-28 01:59:19

Stefan Giudici
2018-11-28 02:01:29

Jason Pook
2018-11-28 02:13:45

Giancarlo Arriola
2018-11-28 03:10:05

Jason Pook
2018-11-28 03:28:30

Kelly Sealey
2018-11-28 04:10:27

原文網址 Bryan Bellerjeau
2018-07-21 09:40:29

Finished a print, removed bed to remove the prints and cleaned it. Still some resin in the tray. Can I just reattatch print bed and print something else, without doing Z leveling all over again?

翻譯年糕

原文網址 Bryan Bellerjeau
2018-07-11 17:59:26

First print! I'm not sure if the lines qualify as 'banding', or are you always going to expect some of this? The middle of the model is hollow, and no weep holes, so is that why it blobbed up towards the bottom? Printed at 45 degree w auto supports on the back. Next test I will add holes at bottom and flipped so it drains.

Was going to share slice pic, but the photon file doesnt load back up in slicer. Is this normal? It show me the slices but doesnt display the model and supports. Do I need to save the stl w supports each time?

翻譯年糕

原文網址 Bryan Bellerjeau
2018-07-01 18:29:46

Looking to buy a Photon, but concerned with the potential for resin smell. Does anyone print in their garage? What % humidity / temperature is acceptible for prints? The garage does get hot, and thinking I'd move printer in/out of garage when cool enough to print through the night.

翻譯年糕

Toby Kirkby
2018-07-01 18:34:18

Fred Williams
2018-07-01 19:09:07