Anycubic Photon Printer Owners 造訪社團

So I’m still having issues with getting miniatures like heroforge to print well. What process do you guys go through to set up your models:

What software do you use?
Auto or manual supports?
What settings do you use for supports?
What orientation do you use and why?

翻譯年糕

Hey guys, just fired up my printer for the first time today and it looks like nothing has attached to the plate. Here is the model and settings I have and the resin was the default green bottle that comes with the printer. I used the google doc guide to set the print specifics. Could use a little help if someone may know whats up. Assuming exposure time?

翻譯年糕

I have a number of models that require a number of parts to be glued together. I've had mixed results using super glue - some have worked perfectly, others just don't seem to want to join. One model in particular doesn't have much surface area between the 2 parts.

Any recommendations as to a better approach?

cheers
Phil

翻譯年糕

Anycubic has released their firmware for the Photon.

翻譯年糕

This looks pretty cool. I know that something like this has been talked about for a while. :-) I figured I would pass it along.

翻譯年糕

has anyone had problems with printer shuting of after it prints bottom layers

翻譯年糕

My Z rod is not moving at all... help plz My Z rod is not moving at all... help plz 翻譯年糕

**Please provide your criticism and reviews***

This is my second attempt after the first failure, in the first attempt i accomodated 8 pieces and filled the built plate almost to each side with only half square left from each side, but in this attempt i decided to increase the cure time from 8 to 12 seconds and reduced one piece inorder to bring all pieces closer to centre, lets see,.

Attempt no 2.
Resin : castable green anycubic
Settings : last pic

翻譯年糕

So I learned yesterday... that resins does not like heat. There's an heat wave for a couple of days now in the US. And usually where i live in sunny southern California and not too far from the beach, i didn't think the heat was going to be bad. Ohhh but it was. Over 100s and being that my apt has no ac (sadness i know) i was mainly surviving with a fan and air purifier.

As you can see in my illustration.

Welp 2 of my resin pokemon prints im working on for someone cracked. So looks like I'll have to start again. I was wondering how well resin does with heat... what do you guys think? Perhaps i didn't cure it long enough?

翻譯年糕

Anybody with experience/settings for Sparkmaker resins ? They don't seem to be on the spreadsheet

翻譯年糕