Anycubic Photon Printer Owners 造訪社團

What' the best color of aftermarket panel for UV blocking? IIRC, it was/is red.

翻譯年糕

Quick question... when printing something like this, do I need to add supports underneath or can I print it flat on the bed like shown? It needs to be an accurate print.

翻譯年糕

How to make it glossy and clear (Part 2)

翻譯年糕

How to make it glossy n clear (Part 1)

翻譯年糕

Does anyone have a suggestion for a castable resin? And what settings to use?

翻譯年糕

Hi, would like to ask for settings to keep the model base directly on the platform without support. Thank u in advance for your suggestions

翻譯年糕

Upgraded to the firmware that Anycubic posted on their site and I can no longer print. Got LCD Error T_100 immediately following the installation. Tried to run the UV test and no rectangle image is displayed on the lcd. Any one else run into this issue or have any suggestions on getting it back up and running again. LCD Firmware v4.1.5. I’ve emailed anycubic also.

*update I failed to “print”the other two files included to complete the update. Printer is back operational again.

翻譯年糕

Can I use an Applywork resin on Anycubic Photon? What are the settings? Thank You!

翻譯年糕

Suggestions to reduce warping on flat layers? They’re pulling my prints off the build plate ? Suggestions to reduce warping on flat layers? They’re pulling my prints off the build plate ? 翻譯年糕

This came up in another forum and I thought it would be good to cover it here. If you are using an Ultrasonic cleaner and put IPA directly into it, be aware that could be considered dangerous. Even if 3d printing nerd did it.

翻譯年糕