Anycubic Photon Printer Owners 造訪社團

I havent been able to get prints stick to the bed yet. Is this most likey a leveling issue? Im just using default settings trying to get anything to print.

翻譯年糕

Hey guys how long can you leave a print attached to bed after the print has finished with out it being an issue

翻譯年糕

Waiting for any cubic team hmmmm

翻譯年糕

I'm constantly impressed by the detail this machine is capable of. This model is about 20mm high (anycubic grey, settings 0.02/10/6.5/90/8). What's the smallest layer height you guys have had success with? I haven't gone any lower than 0.02 so far. Can it actually go lower?

翻譯年糕

Little cherubs - FTD SW .025 / 9s
http://www.cadnav.com/3d-models/model-45560.html

翻譯年糕

Hey guys! In B9 editor, whenever I try to put supports on, it raises the model by exactly 5mm. Can I avoid this?

翻譯年糕

Not sure if this was already posted...

翻譯年糕

Any idea what causes cracks like this? This is pre cured

翻譯年糕

First time printing with monocure rapid gray. What happened to this print? The feet and one elbow look like the layers are falling off. Rest looks pretty good so I'm confused

翻譯年糕

Where do you guys buy your resin from?

翻譯年糕