Anycubic Photon Printer Owners 造訪社團

Hey guys back again print seemed to start off alot better after re leveling got to about 40% and got to this any ideas thanks in advance :)

翻譯年糕

Hi to all of you, maybe somebody can help me, hi bought bluecast kera master resin, and with a bottle I got a sheet with technical information for castable resin. Somebody of you tried this resin with Anycubic Photon and can help me with the exposure parameters?

翻譯年糕

Strange looks as if a certain height exposes something. Empty pressure and already I very much the problem ?

翻譯年糕

Hi mates! Where do you buy resins for your Anycubic Photon?
This info is valuable for us because we are looking for resellers and distributors of HARZ labs resins

翻譯年糕

First try of this big fella on the photon.
Three prints, then assembly.

I failed a few supports on the end of the barrels, but I think the overall effect is pretty nice!

*all credit to the original designer of this. I was so excited when this was uploaded!

翻譯年糕

Hey Vinicius Silva ...

Where are you located? For some reason I feel apprehensive about doing your resin test. If it's feasible, would you be interested in a small amount of the Bucktown resin to run your test on so we all can dial it in?

翻譯年糕

Reveal in a few hours as i am currently away from home ?
*** Monocure Grey - Settings : 0.05layer, normal exposure 11, bottom exposure 40, bottom layers 8 ***

翻譯年糕

Any tips for printing with monocure rapid resin clear, tried a print last night and woke up to a raft nice and firmly secured to the build plate but with no supports and the print stuck to the fep completely flat. Just used the same settings as the Anycubic green.

翻譯年糕

Getting better!

越來越好了!

· 查看原文 · 為此翻譯評分