Anycubic Photon Printer Owners 造訪社團

Ladies and gentlemen
The auction will start within 24 hours.

翻譯年糕

Fresh off the printer. Monocure rapid grey

翻譯年糕

My Anycubic supplied USB drive failed on me. This seems to be a common issue- bad thumb drives.

It came up as invalid when I was trying to move files and said I had to format it. Nothing I tried was able to recover it. When I tried to format it I got an error message that the drive is write protected. Luckily I do IT for a living and have a bunch of PCs and extra USB drives... If anyone from Anycubic is watching this page, there are a lot of reports of bad USB drives or they go bad. This is something to work on...

翻譯年糕

Another test on Thin shell clear n glossy finishing..

Need to wait few minutes to let bubbles gone after paint, put into water to Cure 2 mins.

Gotta test on the inner surface too, see if it can very transparence

翻譯年糕

Just curious is anyone using multiple build plates or vats to speed up swapping resins, recovering after failed prints etc? Not sure how viable it would be as there could be slight variations in vat and build plate that would require calibration each time you swap...

翻譯年糕

What would be the best orientation to print a model like this?

翻譯年糕

Any UK people got a good source of quality FEP for say under £10 per application?

翻譯年糕

Meanwhile I felt like changing the fep sheet . II have not printed anything in a month so I wanted a fresh start. The fep did not fail anything but it seemed a bit cloudy to my eyes. I put some sheet from fepshop (0,150 mm) and did some test prints to see if they are OK. Worked flawlessly.
Btw, I always change the fep directly without a bottle cap or anything like it. I think the video tutorial is wrong and using the cap method can make the fep have too low tension for the platform to be able to unglue the print when it rises. I think a lot of faile prints are related to low-tensioned fep.
Anycubic gray, 60 seconds bottom layer * 4, 9 seconds normal exposure. 0.05 layer height.

翻譯年糕

My F2D IB prints started to crack after 2 months (in house, no direct sun). Hope the Anycubic resin is better, I am really disapointed with f2d with both general frailness and resistence in time :(
edit: all models are hollowed.

翻譯年糕

Need help, what can be the cause for this thing?

翻譯年糕