Anycubic Photon Printer Owners 造訪社團

he is getting bigger ?

翻譯年糕

Any good guide on painting models? I don’t know where to start looking...

翻譯年糕

Hey does anyone here have any idea how to fix this error? Mesh mixers inspector isn't fixing it have no luck so far.

翻譯年糕

Ok I learned something today ? .. on the proton I have, the glass plate over the lcd screen is glued on! Do not try to get it off with a screwdriver like in the instruction video! I cracked the screen and had a very hard time removing it. I had to remove the UV led thing and push the lcd out from the back..

翻譯年糕

Where to find information about resin shrinkage after parts are printed?

Bonus points if someone could point me to a low shrink DLP resin!

翻譯年糕

is it bad for your prints to leave them hang overnight?

翻譯年糕

If I paint 1500 pieces with this much detail, I'm going to go insane...

翻譯年糕

As of July 1st we will be stocking Fun to Do resins at our shop in Sheffield. We will be doing mail order either from our website or phone. We should also have FEP as well

翻譯年糕

Hi, could anyone see what I am doing wrong? On all my prints with Fun To Do Industrial Black, I get some loose film that attaches to the model on different places. You can see it in the first picture. The film is really thin, and is annoying because it can be hard to remove from details.

Also I get some thick layer lines here and there, as you can see on the Deadpool bust. In this example, I think it might be too little support causing it.

I did a calibration with the newest files. Is it correct that column 5 is what I should be calibrating after?

I have been doing 0,035/10,5/0/50/8.

I will be doing another test of a Deadpool bust when I find out about the settings.

翻譯年糕