Anycubic Photon Printer Owners 造訪社團

原文網址 Gabriel Rheault
2018-06-01 04:46:22

a bit of sanding left and next print will be her massive hammer!!

原文網址 Mark Wardle
2018-06-01 04:33:01

About to start printing the world of tanks model of the warhammer 40k kv2 track right hand side i am working on this will be printed solid so fingers crossed with the supports. oh supports added with b9 creations.

翻譯年糕

原文網址 Waldek Wasilewski
2018-06-01 03:53:42

My newest print, painting in progress :D

翻譯年糕

原文網址 Angie Angie
2018-06-01 03:27:30

Help please... I have downloaded the 64 bit v1.3.5 Photon slicer from Anycubic's website.

I am only partially able to view the tool panes on both the left and right hand sides of the screen - they appear to be too narrow and hide details. I cannot see the XYZ values on the left or details for supports on the right.

I have tried reinstalling the program and also changing my screen resolutions with same results. I have also tried installing the program on another laptop with only slightly better results.

My laptop is a Windows 10 - 64 bit.

Any advice would be much appreciated :)

翻譯年糕

原文網址 Stan Codling
2018-06-01 02:37:50

Had the printer two weeks and had an issue which i thought was power supply fan shutting off during set up and needing a restart. Thought i would replace the power supply so another was ordered via Amazon, print just failed at 67 % about 5 hours into the print , fan had switched off and touch screen unreponsive. Board perhaps or bad sd card any thoughts on my problem.

翻譯年糕

原文網址 Nard Janssens
2018-06-01 02:24:14